TGAP-W6610+ is a reliable outdoor wireless Access Point with dual RF IEEE 802.11 a/b/g/n wireless modules and 1 Ethernet Gigabit port with PoE P.D.. It can be configured to operate in AP/ Client /Bridge /AP-Client Mode and supports MAC filters for security control. TGAP-W6610+ provides a dust-tight connection and four N-Type connectors that can install any N-Type antennas to extend communication distance. It is specifically designed for the toughest industrial environments. You are able to configure TGAP-W6610+ by WEB interface via LAN port or WLAN interface. In addition, TGAP-W6610+ also provides P.D. feature that is fully compliant with IEEE802.3af PoE P.D. specification to save the layout cost of power line. TGAP-W6610+ can be easily adopted in almost all kinds of applications and provides the most rugged solutions for managing your network in outdoor. Therefore, TGAP-W6610+ is one of the best communication solutions for wireless applications.
Features
High Speed Air Connectivity: RF in IEEE 802.11 a/b/g/n WLAN interface support up to 300Mbps link speed
Dual RF for redundant wireless communication
Highly Security Capability: WEP/WPA/WPA-PSK(TKIP,AES)/ WPA2/WPA2-PSK(TKIP,AES)/802.1X Authentication supported
Support Long Distance Air Connectivity
Support Multiple-SSID to 4 SSID
Support X-Roaming < 60 ms
Support wireless load balance
Support external N-Type antenna installation
Support AP/ Client /Bridge /AP-Client Mode
Support MAC/IP/Port Filter
Wireless connecting status monitoring
Secured Management by HTTPS
1KV isolation for PoE P.D.
Event Warning by Syslog, Email, SNMP Trap, and Beeper
Rigid IP-67 waterproof housing design
Specifications
| |
TGAP-W6610+ |
TGAP-W6610+-M12 |
| Physical Ports |
|---|
10/100/1000Base-T(X)
Auto MDI/MDIX |
1(RJ45) |
1(M12 8-pin A-coding) |
| PoE P.D. port |
Present at ETH
Fully compliant with IEEE 802.3af Power Device specification
Over load & short circuit protection
Isolation Voltage: 1000 VDC min.
Isolation Resistance : 108 ohms min |
| WLAN interface |
|---|
| Operating Mode |
Dual AP/Dual Client /Bridge /AP-Client Mode |
| Antenna and connector |
4 x External N-Type female antenna connector |
| Radio Frequency Type |
DSSS, OFDM |
| Modulation |
IEEE802.11a : OFDM with BPSK, QPSK, QAM, 64QAM
IEEE802.11b: CCK, DQPSK, DBPSK
IEEE802.11g: OFDM with BPSK, QPSK, 16QAM, 64QAM
IEEE802.11n : BPSK, QPSK, 16-QAM, 64-QAM |
| Frequency Band |
America / FCC : 2.412~2.462 GHz (11 channels)
5.180~5.240 GHz & 5.745~5.825 GHz ( 9 channels )
Europe CE / ETSI : 2.412~2.472 Ghz (13 channels)
5.180~5.240 GHz (4 channels)
|
| Transmission Rate |
IEEE802.11b: 1 / 2 / 5.5 / 11 Mbps
IEEE802.11a/g: 6 / 9 / 12 / 18 / 24 / 36 / 48 / 54 Mbps
IEEE801.11n: up to 300Mbps |
| Transmit Power |
802.11a: 12dBm ± 1.5dBm@54Mbps<br< a="">>802.11b: 17dBm ± 1.5dBm@11Mbps<br< a="">>802.11g: 16dBm ± 1.5dBm@54Mbps<br< a="">>802.11gn HT20: 15dBm ± 1.5dBm @MCS7
802.11gn HT40: 14dBm ± 1.5dBm @MCS7
802.11an HT20: 12dBm ± 1.5dBm @MCS7
802.11an HT40: 11dBm ± 1.5dBm @MCS7 |
| Receiver Sensitivity |
802.11a : -76dBm ± 2dBm@54Mbps<br< a="">>802.11b : -85dBm ± 2dBm@11Mbps<br< a="">>802.11g : -76dBm ± 2dBm@54Mbps<br< a="">>802.11gn HT20:-75dBm ± 2dBm@MCS7<br< a="">>802.11gn HT40:-72dBm ± 2dBm@MCS7<br< a="">>802.11an HT20:-74dBm ± 2dBm@MCS7<br< a="">>802.11an HT40:-71dBm ± 2dBm@MCS7> |
| Encryption Security |
WEP: (64-bit ,128-bit key supported)
WPA/WPA2 :802.11i(WEP and AES encryption)
WPAPSK (256-bit key pre-shared key supported)
802.1X Authentication supported
TKIP encryption |
| Wireless Security |
SSID broadcast disable and enable |
| Protocol Support |
|---|
| Protocol |
ARP,BOOTP, DHCP, DNS, HTTP, IP, ICMP, SNTP, TCP, UDP, RADIUS, SNMP, STP, RSTP |
| LED Indicators |
|---|
| Power Indicator |
3 x LEDs, PW1/PW2/PoE Green On : Power is on and booting up |
| 10/100/1000TX M12 Port Indicator |
1 x LEDs, Green for port Link/Act |
| WLAN LEDs |
2 x LEDs, Green for WLAN Link/Act |
| Fault |
1 x LED, Red for Ethernet link down or power down indicator |
| Power |
|---|
| Redundant Input Power |
Dual Power Inputs. 12~48 VDC |
| Power Consumption (Typ.) |
11 Watts |
| Physical Characteristic |
|---|
| Enclosure |
IP-67 |
| Dimension (W x D x H) |
310 (W) x 310(D) x 87 (H) (12.2 x 12.2 x 3.4 inch) |
| Weight (g) |
|
3980 g |
| Environmental |
|---|
| Storage Temperature |
-40 to 85°C (-40 to 185°F) |
| Operating Temperature |
-25 to 70°C (-13 to 158°F) |
| Operating Humidity |
5% to 95% Non-condensing |
| Regulatory approvals |
|---|
| EMI |
FCC Part 15, CISPR (EN55022) class A, EN50155 (EN50121-3-2, EN55011, EN50121-4) |
| EMS |
EN61000-4-2 (ESD), EN61000-4-3 (RS), EN61000-4-4 (EFT), EN61000-4-5 (Surge), EN61000-4-6 (CS), EN61000-4-8, EN61000-4-11 |
| Rail Traffic |
EN50155 |
| Shock |
IEC60068-2-27, EN61373 |
| Free Fall |
IEC60068-2-31 |
| Rail Traffic |
EN50155 |
| Vibration |
IEC60068-2-6, EN61373 |
| Rail Traffic |
EN50155 |
| Cooling |
EN60068-2-1 |
| Dry Heat |
En60068-2-2 |
| Safety |
EN60950-1 |
| Warranty |
5 years |
Accessories
| Model No. | Description |
|---|
| DR-120 series |
120W DIN-Rail power supply series |
| DR-45 series |
45W DIN-Rail power supply series |
| DR-75 series |
75W DIN-Rail power supply series |
| RF Antenna Base Series |
RF Antenna Base Series |
| RF Cable Series |
RF Cable Series |
| WLAN RF Antenna Series |
WLAN RF Antenna Series |