TGAP-6620-M12 Series

Industrial EN50155 Dual RF in IEEE 802.11 a/b/g/n Wireless AP with 2x10/100/1000Base-T(X), M12 connector

 

TGAP-6620-M12 is a reliable WLAN Access Point with 2 Ethernet Gigabit ports and dual RF in IEEE 802.11 a/b/g/n wireless modules. It can be configured to operate in Dual AP/Dual Client /Bridge /AP-Client Mode. In combination with its IP-40 design and the superb management functionality, TGAP-6620-M12 provides a dust-tight connection and reverse SMA-type connectors, that can install any reverse SMA-type antennas to extend communication distance. It is specifically designed for the toughest industrial environments. You are able to configure TGAP-6620-M12 by WEB interface via LAN port or WLAN interface. TGAP-6620-M12 can be easily adopted in almost all kinds of applications and provides the most rugged solutions for managing your network in outdoor. In addition, TGAP-6620+-M12 also provides P.D. feature on ETH2 which is fully compliant with IEEE802.3af PoE P.D. specification. Therefore, TGAP-6620-M12 is one of the best communication solutions for wireless applications.

Features

 High Speed Air Connectivity: WLAN interface support up to 300 Mbps link speed

 Highly Security Capability: WEP/WPA/WPA-PSK(TKIP,AES)/ WPA2/WPA2-PSK(TKIP,AES)/802.1X Authentication supported

 Dual Gigabit Ethernet ports support switch mode in M12 connector (A-coding)

 Support X-Roaming < 60 ms

 Support wireless load balance

 Support Multiple-SSID to 4 SSID

 Support external SMA antenna installation

 Support dual AP/Dual Client /Bridge /AP-Client Mode

 Support MAC Filter

 Wireless connecting status monitoring

 1KV isolation for PoE P.D. port for TGAP-6620+-M12 • Secured Management by HTTPS

 Event Warning by Syslog, Email, SNMP Trap, and Relay output

 Rigid IP-40 housing design

 Wall-mount enabled

Specifications

TGAP-6620-M12 TGAP-6620+-M12
Physical Ports 
100/1000Base-T(X) Ports in M12 Auto MDI/MDIX (8-pin A-coding) 2 2 (Present at ETH2 Fully Compiant with IEEE 802.3af PoE P.D.)
DIDO port in M12 (A-Coding)

2(DI x 4 and DO x 4) 
Dry Contact: 
 On: short to GND, off: open 
Wet Contact(DI to COM/GND): 
 On: 0 to 3VDC, off: 10 to 30VDC

RS-232 Console port in M12 (5-pin A-coding) 115200, 8 ,N ,1
Antenna Connector 4
 Relay port in M12 (5-pin A-coding)  1A@24VDC>
WLAN interface 
Operating Mode AP/Bridge/Repeater/AP-Client
Antenna and connector 4 x Reverse SMA Female
Radio Frequency Type DSSS
Modulation IEEE802.11b: CCK, DQPSK, DBPSK
IEEE802.11a/g: OFDM with BPSK, QPSK, 16-QAM, 64-QAM
IEEE802.11n: OFDM with BPSK, QPSK, 16-QAM, 64-QAM
Frequency Band

America/FCC: 2.412~2.462 GHz (11 channels)
                     5.180~5.240 GHz & 5.745~5.825 GHz (9 channels)
Europe CE/ETSI: 2.412~2.472 Ghz (13 channels)
                       5.180~5.240 GHz  (4 channels)
 

Transmission Rate IEEE802.11b: 1 / 2 / 5.5 / 11 Mbps
IEEE802.11a/g: 6 / 9 / 12 / 18 / 24 / 36 / 48 / 54 Mbps 
IEEE801.11n: up to 300Mbps
Transmit Power 802.11a: 12dBm ± 1.5dBm@54Mbps<br< a="">>802.11b: 17dBm ± 1.5dBm@11Mbps<br< a="">>802.11g: 16dBm ± 1.5dBm@54Mbps<br< a="">>802.11gn HT20: 15dBm ± 1.5dBm @MCS7
802.11gn HT40: 14dBm ± 1.5dBm @MCS7
802.11an HT20: 12dBm ± 1.5dBm @MCS7
802.11an HT40: 11dBm ± 1.5dBm @MCS7
Receiver Sensitivity 802.11a : -76dBm ± 2dBm@54Mbps<br< a="">>802.11b : -85dBm ± 2dBm@11Mbps<br< a="">>802.11g : -76dBm ± 2dBm@54Mbps<br< a="">>802.11gn HT20:-75dBm ± 2dBm@MCS7<br< a="">>802.11gn HT40:-72dBm ± 2dBm@MCS7<br< a="">>802.11an HT20:-74dBm ± 2dBm@MCS7<br< a="">>802.11an HT40:-71dBm ± 2dBm@MCS7>
Encryption Security

WEP: (64-bit ,128-bit key supported)
WPA/WPA2 :802.11i(WEP and AES encryption)
WPAPSK (256-bit key pre-shared key supported)
802.1X Authentication supported
TKIP encryption

Wireless Security SSID broadcast disable and enable
Protocol Support 
Protocol ARP,BOOTP, DHCP, DNS, HTTP, IP, ICMP, SNTP, TCP, UDP, RADIUS, SNMP, STP, RSTP
LED Indicators 
Power Indicator 2 x LEDs, Green for Power on
10/100/1000TX RJ45 Port Indicator 2 x LEDs, Green for port Link/Act
WLAN LED 2 x LEDs, Green for WLAN Link/Act
Fault 1 x LED, Red for Ethernet link down or power down indicator
Fault contact 
Relay Relay output to carry capacity of 1A at 24VDC(5-pin M12 A-coding)
Power 
Redundant Input Power Dual Power Inputs. 12~48 VDC 
Power Consumption (Typ.) 11 Watts 11.5 Watts
Physical Characteristic 
Enclosure IP-40
Dimension (W x D x H) 125.6(W) x 65(D) x 196.1(H) mm (4.94 x 2.55 x 7.72 inch.)
Weight (g) 980 g 985 g
Environmental 
Storage Temperature -40 to 85°C (-40 to 185°F)
Operating Temperature -25 to 70°C (-13 to 158°F)
Operating Humidity 5% to 95% Non-condensing
Regulatory approvals 
EMI FCC Part 15, CISPR (EN55022) class A, EN50155 (EN50121-3-2, EN55011, EN50121-4)
EMS EN61000-4-2 (ESD), EN61000-4-3 (RS), EN61000-4-4 (EFT), EN61000-4-5 (Surge), EN61000-4-6 (CS), EN61000-4-8, EN61000-4-11
Shock IEC60068-2-27, EN61373
Free Fall IEC60068-2-31
Vibration IEC60068-2-6, EN61373
Safety EN60950-1
Warranty 5 years

Available Model

Model No.Description
TGAP-6620-M12_US Industrial EN50155 Dual RF in IEEE 802.11 a/b/g/n Wireless AP with 2x10/100/1000Base-T(X), M12 connector, US band
TGAP-6620-M12_EU Industrial EN50155 Dual RF in IEEE 802.11 a/b/g/n Wireless AP with 2x10/100/1000Base-T(X), M12 connector, EU band
TGAP-6620+-M12_EU Industrial EN50155 Dual RF in IEEE 802.11 a/b/g/n Wireless AP with 2x10/100/1000Base-T(X), M12 connector, 1-port PoE P.D, EU band
TGAP-6620+-M12_US Industrial EN50155 Dual RF in IEEE 802.11 a/b/g/n Wireless AP with 2x10/100/1000Base-T(X), M12 connector, 1-port PoE P.D, US band

Accessories

Model No.Description
DR-45 series 45W DIN-Rail power supply series
DR-75 series 75W DIN-Rail power supply series
DR-120 series 120W DIN-Rail power supply series
RF Antenna Base Series RF Antenna Base Series
RF Cable Series RF Cable Series
WLAN RF Antenna Series WLAN RF Antenna Series