IAP-620/620+

Industrial IEEE 802.11 a/b/g/n wireless access point with 2x10/100Base-T(X)

 

IAP-620 series are reliable IEEE802.11 a/b/g/n WLAN Access Point with 2 ports LAN. It supports 802.1X and MAC filters for security control. It can be configured to operate in AP/Bridge/Repeater/AP-Client mode. You are able to configure IAP-620 series by WEB interface via LAN port or WLAN interface.IAP-620 series provides dual Ethernet ports in switch mode, so that you can use Daisy Chain to reduce the usage of Ethernet switch ports. In addition, IAP-620 series also provides P.D. feature on ETH2 which is fully compliant with IEEE802.3af PoE P.D. specification. Therefore, IAP-620 series are one of the best communication solutions for wireless applications on the industrial network.

Features

High Speed Air Connectivity: WLAN interface support up to 300Mbps link speed

Support X-Roaming < 100 ms

Support wireless load balance

Highly Security Capability: WEP/WPA/WPA-PSK(TKIP,AES)/ WPA2/WPA2-PSK(TKIP,AES)/802.1X   Authentication supported

Support AP/Bridge/Repeater/AP-Client Mode

Switch Mode Supported: Daisy Chain support to reduce usage of switch ports

Dual redundant Ethernet port support redundant mode (Recovery time < 10ms)

Secured Management by HTTPS

Event Warning by Syslog, Email, SNMP Trap, Relay and Beeper

Rigid IP-30 housing design

DIN-Rail and panel mounting enabled

Specifications

  IAP-620 IAP-620+
Physical Ports  
10/100Base-T(X) Ports in RJ45 Auto MDI/MDIX                                                                                     2
P.O.E. PD port Present at ETH2
Fully compliant with IEEE 802.3af   Power
Device specifi cation
Over load & short circuit protection
Isolation Voltage : 1000 VDC min.
Isolation Resistance : 108 ohms min
WLAN interface  
Operating Mode AP/Bridge/Repeater/AP-Client
Antenna and connector 2dBi ( b/g mode) / 3dBi ( a mode ) antenna on reverse SMA connector
Radio Frequency Type DSSS, OFDM
Modulation IEEE802.11a/n : OFDM with BPSK, QPSK, 16QAM, 64QAM
IEEE802.11b : CCK, DQPSK, DBPSK
IEEE802.11g/n : OFDM with BPSK, QPSK, 16QAM, 64QAM
Frequency Band America / FCC:
2.412~2.462 GHz (11 channels )
5.180~5.240 GHz & 5.745~5.825 GHz ( 9 channels )
Europe CE / ETSI:
2.412~2.472 GHz ( 13 channels )
5.180~5.240 GHz ( 4 channels )
Japan(JP):
2.412~2.484 GHz ( 13 channels )
5.180~5.240 GHz ( 4 channels )
Canada(CA):
2.412~2.462 GHz ( 11 channels )
5.180~5.825 GHz ( 21 channels )
Transmission Rate IEEE802.11b : 1/ 2/ 5.5/ 11 Mbps
IEEE802.11a/g : 6/ 9/ 12/ 18/ 24/ 36/ 48/ 54 Mbps
IEEE802.11n : up to 300Mbps
Transmit Power 802.11a: 13dBm ±1.5dBm
802.11b: 16dBm ±1.5dBm
802.11g: 14dBm ±1.5dBm
802.11n(2.4G@20MHz): 13dBm ±1.5dBm
802.11n(2.4G@40MHz): 12dBm ±1.5dBm
802.11n(5G@20MHz): 12dBm ±1.5dBm
802.11n(5G@40MHz): 12dBm ±1.5dBm
Receiver Sensitivity 802.11a: -68dBm ±2dBm@54Mbps<br< a="">>802.11b: -82dBm ±2dBm@11Mbps<br< a="">>802.11g: -68dBm ±2dBm@54Mbps<br< a="">>802.11n(2.4G@20MHz,MCS15): -64dBm ±2dBm
802.11n(2.4G@40MHz,MCS15): -60dBm ±2dBm
802.11n(5G@20MHz,MCS15): -64dBm ±2dBm
802.11n(5G@40MHz,MCS15): -60dBm ±2dBm
Encryption Security WEP : (64-bit ,128-bit key supported)
WPA :
WPA2 : 802.11i(WEP and AES encryption)
PSK (256-bit key pre-shared key supported)
802.1X Authentication supported
TKIP encryption
Wireless Security SSID broadcast disable
Protocol Support  
Protocol ARP, BOOTP, DHCP, DNS, HTTPs, IP, ICMP, SNTP, TCP, UDP, RADIUS, SNMP, STP (IEEE 802.1D)
LED Indicators  
Power Indicator PWR 1(2)(P.O.E.) / Ready :
Red On : Power is on and booting up.
Green On : Power is on and functioning Normally.
10/100TX RJ45 Port Indicator Green for port Link/Act at 100Mbps. Amber for port Link/Act at 10Mbps
WLAN LEDs WLAN Link /ACT : Green : Link, Orange : Poor signal
WLAN Strength : 1<25%, 2<50%, 3<75%, 4<100%
Fault Red : Ethernet link down or power down
Fault contact  
Relay Relay output to carry capacity of 1A at 24VDC
Power  
Redundant Input Power Dual DC inputs. 12-48VDC on 6-pin terminal block Triple DC inputs, 48VDC from PoE and Dual 12~48VDC on 6-pin terminal block
Power Consumption (Typ.) 6 Watts
Overload Current Protection Present
Reverse Polarity Protection Present
Physical Characteristic  
Enclosure IP-30
Dimension (W x D x H) 54.2(W) x 106.1(D) x 145.4(H) mm (2.13x4.18x5.72 inch.)
Weight (g) 803 g 807 g
Environmental 
Storage Temperature -40 to 85°C (-40 to 185°F)
Operating Temperature -10 to 60°C (14 to 140°F)
Operating Humidity 5% to 95% Non-condensing
Regulatory approvals  
EMI FCC Part 15, CISPR (EN55022) class A
EMS EN61000-4-2 (ESD), EN61000-4-3 (RS), EN61000-4-4 (EFT), EN61000-4-5 (Surge), EN61000-4-6 (CS),EN61000-4-8, EN61000-4-11
Shock IEC60068-2-27
Free Fall IEC60068-2-32
Vibration IEC60068-2-6
Safety EN60950-1
MTBF (Hours) (MIL-HDBK-217F2, GB, GC, 25°C ) 352,982 352,594
Warranty 3 years

 

Available Model

Model No.Description
IAP-620_US Industrial IEEE 802.11 a/b/g/n wireless access point with 2x10/100Base-T(X), US band
IAP-620_EU Industrial IEEE 802.11 a/b/g/n wireless access point with 2x10/100Base-T(X), EU band
IAP-620_JP Industrial IEEE 802.11 a/b/g/n wireless access point with 2x10/100Base-T(X), JP band
IAP-620_CA Industrial IEEE 802.11 a/b/g/n wireless access point with 2x10/100Base-T(X), CA band
IAP-620+_EU Industrial IEEE 802.11 a/b/g/n wireless access point with 2x10/100Base-T(X), 1-port PoE P.D, EU band
IAP-620+_US Industrial IEEE 802.11 a/b/g/n wireless access point with 2x10/100Base-T(X), 1-port PoE P.D, US band
IAP-620+_JP Industrial IEEE 802.11 a/b/g/n wireless access point with 2x10/100Base-T(X), 1-port PoE P.D, JP band
IAP-620+_CA Industrial IEEE 802.11 a/b/g/n wireless access point with 2x10/100Base-T(X), 1-port PoE P.D, CA band

Accessories

Model No.Description
DR-45 series 45W DIN-Rail power supply series
DR-75 series 75W DIN-Rail power supply series
DR-120 series 120W DIN-Rail power supply series
RF Antenna Base Series RF Antenna Base Series
RF Cable Series RF Cable Series
RF Surge Protector Series RF Surge Protector Series
WLAN RF Antenna Series WLAN RF Antenna Series