IGAR-2062+-3G

Industrial IEEE 802.11 a/b/g/n Dual 3G Cellular Router with 2x10/100/1000Base-T(X)

IGAR-2062+-3G
zoom Zoom image
 

IGAR-2062+-3G is a reliable IEEE 802.11 a/b/g/n WLAN VPN router with 2 ports 10/100/1000Base-T(X) router where ETH1 for LAN and ETH2 for WAN. It supports 802.1X and MAC filter for security control. It could be configured to operate in 3 modes of routing function: Dynamic/Static IP route, PPPoE authentication, and Modem dial up. In the mode of Modem dial up, it support GPRS/3G/3.5G modem by internal 3G module. Users can set up WLAN environment to fulfill demands of various applications rapidly by dual SIM dialing up cellular modems. In addition, IGAR-2062+-3G provides P.D. feature on ETH2 which is fully compliant with IEEE802.3af PoE P.D. specification. This feature extends the layout up to 100 meters. Therefore, IGAR-2062+-3G is one of the best solution for applications of wireless communication.

Features

High Speed Air Connectivity: WLAN interface support up to 300Mbps link speed

Provide 2 port 10/100/1000Base-T(X) port and 1 sim card slot

Support dual UMTS dial up

Provide HNAT enhance LAN to WAN routing performance

Highly Security Capability: WEP/WPA/WPA-PSK(TKIP,AES)/ WPA2/WPA2-PSK(TKIP,AES)/802.1X Authentication supported

Secured Management by HTTPs

Various kind of WAN Connection Type supported: Dynamic/Static IP, PPPoE, Modem/Dial Up

Support client operating mode

IP table to prevent access from unauthorized IP address

Support VPN for secured network connection (Open VPN , PPTP, IPSEC VPN)

Support NAT Setting (Virtual Server , Port Trigger , DMZ , UPnP)

3G Modem signal information display (un-connecting status)

Wireless connecting status monitoring

Versatile modes & event alarm by e-mail

1KV isolation for PoE P.D. port 

Event Warning by Syslog, Email, SNMP Trap, Relay and Beeper

Rigid IP-30 housing design

DIN-Rail and Wall-mount enabled

Specifications

  IGAR-2062+-3G
Physical Ports  
10/100/1000Base-T(X) Ports in RJ45 Auto MDI/MDIX 2
P.O.E. PD port

Present at ETH2
Fully compliant with IEEE 802.3af   Power
Device specifi cation
Over load & short circuit protection
Isolation Voltage : 1000 VDC min.
Isolation Resistance :10^8 ohms min
5-Pin Terminal Block 2(DI x 4 and DO x 4)
Sim Card Slot 2
Cellular Interface  
Cellualr Standard GSM / GPRS/ EGPRS/ EDGE / WCDMA / HSDPA / HSUPA
Band Option Dual-band : HSUPA 1900/2100 MHz
Quad-band : GSM/GPRS/EDGE 850/900/1800/1900 MHz
WCDMA/HSDPA 850/900/1900/2100 MHz
WLAN interface  
Operating Mode AP/Bridge/Repeater/AP-Client
Antenna and connector Reverse SMA Female
Radio Frequency Type DSSS
Modulation IEEE802.11b: CCK, DQPSK, DBPSK
IEEE802.11a/g: OFDM with BPSK, QPSK, 16-QAM, 64-QAM
IEEE802.11n: OFDM with BPSK, QPSK, 16-QAM, 64-QAM
Frequency Band America / FCC:
2.412~2.462 GHz (11 channels )
5.180~5.240 GHz & 5.745~5.825 GHz ( 9 channels )
Europe CE / ETSI:
2.412~2.472 GHz ( 13 channels )
5.180~5.240 GHz ( 4 channels )
Transmission Rate IEEE802.11b: 1/ 2/ 5.5/ 11 Mbps
IEEE802.11a/g: 6/ 9/ 12/ 18/ 24/ 36/ 48/ 54 Mbps
IEEE802.11n:up to 300Mbps
Transmit Power 802.11a: 12dBm ± 1.5dBm@54Mbps<br< a="">>802.11b: 17dBm ± 1.5dBm@11Mbps<br< a="">>802.11g: 16dBm ± 1.5dBm@54Mbps<br< a="">>802.11gn HT20: 15dBm ± 1.5dBm @MCS7
802.11gn HT40: 14dBm ± 1.5dBm @MCS7
802.11an HT20: 12dBm ± 1.5dBm @MCS7
802.11an HT40: 11dBm ± 1.5dBm @MCS7
Receiver Sensitivity 802.11a : -76dBm ± 2dBm@54Mbps<br< a="">>802.11b : -85dBm ± 2dBm@11Mbps<br< a="">>802.11g : -76dBm ± 2dBm@54Mbps<br< a="">>802.11gn HT20:-75dBm ± 2dBm@MCS7<br< a="">>802.11gn HT40:-72dBm ± 2dBm@MCS7<br< a="">>802.11an HT20:-74dBm ± 2dBm@MCS7<br< a="">>802.11an HT40:-71dBm ± 2dBm@MCS7<p< a="">> 
Encryption Security WEP: (64-bit ,128-bit key)
WPA/WPA2 PSK :TKIP and AES encryption (802.11i)
802.1X/RADIUS Authentication supported
Wireless Security SSID broadcast disable
LED Indicators  
Power Indicator 3 x LEDs, PWR1(2)(PoE) / Ready:
   Red On : Power is on and booting up
   Green On : Power is on and functioning Normal
10/100/1000T RJ45 Port Indicator 2 x LEDs,
LNK/ACT:Green for port Act.
Speed: Green for port Link at 1000Mbps
            Amber for port Link at 100Mbps.
            Off for port Link at 10Mbps
WLAN LEDs Green Solid On: RF on, Blink: data transmitting
Green for WLAN Strength: 1<25%, 2<50%, 3<75%, 4<100%
WAN LEDs 2 x LEDs, Green On : Power is on and functioning Normal
Fault 1 x LED, Red for Ethernet link down or power down indicator
Fault contact  
Relay Relay output to carry capacity of 1A at 24VDC
Power  
Redundant Input Power Dual DC inputs. 12-48VDC on 6-pin terminal block
Power Consumption (Typ.) 9.5W
Overload Current Protection Present
Reverse Polarity Protection Present
Physical Characteristic  
Enclosure IP-30
Dimension (W x D x H) 74.3(W) x 109.2(D) x 153.6(H) mm (2.93 x 4.3 x 6.05 inch.)
Weight (g) 1155
Environmental 
Storage Temperature -40 to 85°C (-40 to 185°F)
Operating Temperature -25 to 70°C (-13 to 158°F)
Operating Humidity 5% to 95% Non-condensing
Regulatory approvals  
EMI FCC Part 15, CISPR (EN55022) class A
EMS EN61000-4-2 (ESD), EN61000-4-3 (RS), EN61000-4-4 (EFT), EN61000-4-5 (Surge), EN61000-4-6 (CS),EN61000-4-8, EN61000-4-11
Shock IEC60068-2-27
Free Fall IEC60068-2-32
Vibration IEC60068-2-6
Safety EN60950-1
Warranty 5 years

 

Available Model

Model No.Description
IGAR-2062+-3G_US Industrial IEEE 802.11 a/b/g/n Dual 3G Cellular router with 2x10/100/1000Base-T(X), 1-port PoE P.D., US band
IGAR-2062+-3G_EU Industrial IEEE 802.11 a/b/g/n Dual 3G Cellular router with 2x10/100/1000Base-T(X), 1-port PoE P.D., EU band

Accessories

Model No.Description
DR-120 series 120W DIN-Rail power supply series
DR-45 series 45W DIN-Rail power supply series
DR-75 series 75W DIN-Rail power supply series
WLAN RF Antenna Series WLAN RF Antenna Series
 
 
 

Main Search Products catalog Mail Contacts